I f you can Hear Two Beeps, Please follow my other documents. To fix this problem, please follow “Qnap firmware Recovery / Reflash” Documents. If you cannot Hear the two beeps, the NAS Firmware is Damaged. If you cannot hear first beep, Please contact your local reseller or distributor for repair or replacement service. You will hear a beep after pressing the power button, followed by 2 beeps 2 minutes later. I take this document from Qnap helpdesk, It continues with “send it to technical departmant”, but you can solve it by yourself, so please keep on reading my fixed document If you still cannot access the NAS after Step 3, please do the following: This will clear the administrator password and network settings (DHCP will be used and the default user name and password is: admin/admin).After two beeps on the system startup, run the Finder again to find your NAS or open a web browser and enter (If your NAS is connected to your PC directly, the NAS IP is 169.254.100.100:8080). Reset the NAS by pressing the reset button for 3–4 seconds.If the Status/Power LED flashes red or red and green alternatively, the NAS is not initialized or the hard drive(s) are not ready. Check if the Status LED (same as the Power LED for some models) glows green.Check your LAN cable connection and the LAN LED is flashing.Seems its retaining some IP config assignments in use from your old router. If you still cannot access your NAS by the Finder or by entering the NAS IP in the web browser directly, please do the following: If your QNAP says it has an IP address of 192.168.1.x, theres your issue, since Eeros default to 192.168.7.x, and for any device to be usable it must match the Eeros gateway and IP range. Important: Check the NAS MAC address to ensure the NAS on the list is yours. Select the NAS with the folders you want to mount from the list. Tip: If you cannot find the NAS, make sure that it is on the same network as your computer. If the problem persists, check if other anti-virus programs or firewalls are running disable them and run the Finder again. Qfinder Pro automatically searches and lists all QNAP NAS on the same network. Windows 7 users can click “Allow access” to unblock the Finder from Windows Firewall. If you are using Windows XP SP2, click “Unblock” when the Windows Firewall dialog appears to run the Finder. Uncheck the option “Internet Connection Firewall”.Click “Properties” and select “Advanced” tab.Click “Network Connections” and double click the icon for your network connection.Go to “Control Panel” > “Network and Internet Connections” in the Category view or go to “Network Settings” > “Control Panel” in the Classic view.If you are using Windows XP SP1, please do the following: Make sure your NAS and the PC are connected to the network correctly. What is RAID? Redundant Array of Independent Disks.Warning : Re-Launch Process & The File System Is Not Clean.Qnap Becomes Unreachable When I Plug Qnap to My Network.Web-based Distributed Authoring and Versioning (WebDAV).What is Stress Test and How to Do Guide.Qnap Benchmark, Lun Speed & Stability Test. With Linux and ZFS, QuTS hero supports advanced data reduction technologies for further driving down costs and increasing reliablility of SSD (all-flash) storage. QuTS hero is the operating system for high-end and enterprise QNAP NAS models. WIth Linux and ext4, QTS enables reliable storage for everyone with versatile value-added features and apps, such as snapshots, Plex media servers, and easy access of your personal cloud. QTS is the operating system for entry- and mid-level QNAP NAS.
0 Comments
Leave a Reply. |